Auto-Off Timeout Change value

[jrozsas]

I have the habit of performing calculations and write something but often it takes more than 5 minutes. This is the standard time for the calculator to enter auto off mode.
But those who wish to change this time is easy.
The TOff command shows the time in milliseconds and to see the value in seconds type TOff / (60 * 1000).

To change, simply enter TOff: = # 927C0h to 10 minutes for example

Valid values are between #1388h to #3FFFFFFFh
You can enter lower values, 2 minutes, to save battery it:
TOff:=#1D4C0h

[Thomas_Sch]

Hello jrozsas,
please have also a look at this little program by Wolfgang:
http://www.hpmuseum.org/forum/thread-2815.html

Thomas

[KlaasKuperus]

(02-10-2016 07:23 PM)Thomas_Sch Wrote:  Hello jrozsas,
please have also a look at this little program by Wolfgang:
http://www.hpmuseum.org/forum/thread-2815.html

Thomas

Nice program Thomas!

[Thomas_Sch]

Thanks.
The honor goes to Wolfgang.
I added only the slider.

[jrozsas]

(02-10-2016 07:23 PM)Thomas_Sch Wrote:  Hello jrozsas,
please have also a look at this little program by Wolfgang:
http://www.hpmuseum.org/forum/thread-2815.html

Thomas

There are several programs that are changing the shutdown time.
This is another one that also does the same function: https://www.cemetech.net/programs/index....le&id=1291
However, the change in command line seems to be simpler, especially when there is no need for constant change. It is also important that people know that the statement that really makes this change.

[Thomas_Sch]

(02-11-2016 01:19 PM)jrozsas Wrote:  ..
There are several programs that are changing the shutdown time.
This is another one that also does the same function: https://www.cemetech.net/programs/index....le&id=1291
However, the change in command line seems to be simpler, especially when there is no need for constant change. It is also important that people know that the statement that really makes this change.

I see.
Youd didn't check this one?

[jrozsas]

(02-12-2016 07:45 PM)Thomas_Sch Wrote:  

(02-11-2016 01:19 PM)jrozsas Wrote:  ..
There are several programs that are changing the shutdown time.
This is another one that also does the same function: https://www.cemetech.net/programs/index....le&id=1291
However, the change in command line seems to be simpler, especially when there is no need for constant change. It is also important that people know that the statement that really makes this change.

I see.
Youd didn't check this one?

I installed them and work very well. Including serving as an example to the slidebar.
The command element (0..5) could be used to create the slider?
See: http://en.hpprime.club/docs/reference/element

[Thomas_Sch]

(02-12-2016 08:53 PM)jrozsas Wrote:  I installed them and work very well. Including serving as an example to the slidebar.
The command element (0..5) could be used to create the slider?
See: http://en.hpprime.club/docs/reference/element

Thanks for the tip! Sounds very interesting.
Refering to the manual, (User_Guide_EN_2015_06_17_1.pdf, pg 184), 'element' belongs to the geometry app.
It is time to take a deeper look at this app ...