Hp25c
|
06-20-2018, 09:02 PM
Post: #1
|
|||
|
|||
Hp25c
It lives! It’s working 100% ok.
Thanks to this thread below. http://www.hpmuseum.org/cgi-sys/cgiwrap/...read=12608 It just needed a little aluminum foil wrapped around the terminal leads. Im using a shapeways plastic power pack with a copper dual coiled spring Question, is there a more permanent solution for the terminal leads? The aluminum foil falls off when the pack is pulled out. I can solder, but dont want to mess up the 25c terminal leads and do it incorrectly. |
|||
06-21-2018, 07:53 AM
Post: #2
|
|||
|
|||
RE: Hp25c
(06-20-2018 09:02 PM)dm123 Wrote: Question, is there a more permanent solution for the terminal leads? I think the ideal solution would be to insert new silver rivets in place of the corroded ones. Some time ago I bought a bag full on eBay but unfortunately they are metric size and a tiny bit too small to make good contact. So double check before ordering... |
|||
06-21-2018, 11:39 AM
Post: #3
|
|||
|
|||
RE: Hp25c
(06-20-2018 09:02 PM)dm123 Wrote: Question, is there a more permanent solution for the terminal leads? SCNR Greetings, Massimo -+×÷ ↔ left is right and right is wrong |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)