Arg on HP Prime

[Plantarum]

Dear fellow HP users,

This may have been asked before or a stupid question, but I can't figure out where the ARG function is on the Prime.
I have used HP 48 and 50 since they came out and after calculation, you could do right shift EEX to get the arguments back on the screen.
Say 10 enter 5 +
Answer 15
Richt shift EEX (ARG) will show 10 and 5 again.

This is a very useful function and I can not find it on the prime.
I like to use the calculator in RPN, because I am used to that, but in that mode the arguments are not automatically shown on the left side of the screen.

Any help is much appreciated,

Hubert

[Stevetuc]

(08-15-2020 10:03 AM)Plantarum Wrote:  Dear fellow HP users,

This may have been asked before or a stupid question, but I can't figure out where the ARG function is on the Prime.
I have used HP 48 and 50 since they came out and after calculation, you could do right shift EEX to get the arguments back on the screen.
Say 10 enter 5 +
Answer 15
Richt shift EEX (ARG) will show 10 and 5 again.

This is a very useful function and I can not find it on the prime.
I like to use the calculator in RPN, because I am used to that, but in that mode the arguments are not automatically shown on the left side of the screen.

Any help is much appreciated,

Hubert

Shift Ans should do it.

[Plantarum]

Thanks,

Sorted now.
Was a bit hard to find after changing the command.