Threaded Mode | Linear Mode

isanchez · 05-15-2015, 10:31 AM

Hi,
is there any succesful way to remove the keyboard label of an HP41C?
I have got one in bad state that could be replaced from a donor.
Maybe heating with a hairdryer would help? Do you have any experience?

Thanks in advance

Kind regards

Ignacio

TASP · 05-15-2015, 12:56 PM

My first impulse would be to put an overlay over the marred label.

Am I missing something ??

(it's early here and I'm not too perky yet, LOL)

Ángel Martin · (This post was last modified: 05-19-2015 11:03 AM by Ángel Martin.)

(05-15-2015 12:56 PM)TASP Wrote: My first impulse would be to put an overlay over the marred label.

I had the same though - and a few sticker overlays that could fit the bill. Mind you, not for the standard keyboard but the SandMath, and 41Z; thus you'd have that looking at you permanently which can be perhaps overwhelming and probably not what you want.

isanchez · 05-19-2015, 09:07 AM

Hi,
just to report that I have done it, with the help of a hairdryer.
It looks acceptable, but it has some bends and marks that are very difficult to avoid.

Thanks a kind regard

Ignacio

Jose Gonzalez Divasson · 05-23-2015, 01:30 PM

Ignacio, good luck with it!