Post Reply 
HP41C keyboard label remove
05-15-2015, 10:31 AM
Post: #1
HP41C keyboard label remove
Hi,
is there any succesful way to remove the keyboard label of an HP41C?
I have got one in bad state that could be replaced from a donor.
Maybe heating with a hairdryer would help? Do you have any experience?

Thanks in advance

Kind regards

Ignacio
Find all posts by this user
Quote this message in a reply
05-15-2015, 12:56 PM
Post: #2
RE: HP41C keyboard label remove
My first impulse would be to put an overlay over the marred label.

Am I missing something ??

(it's early here and I'm not too perky yet, LOL)

2speed HP41CX,int2XMEM+ZEN, HPIL+DEVEL, HPIL+X/IO, I/R, 82143, 82163, 82162 -25,35,45,55,65,67,70,80
Find all posts by this user
Quote this message in a reply
05-16-2015, 06:41 AM (This post was last modified: 05-19-2015 11:03 AM by Ángel Martin.)
Post: #3
RE: HP41C keyboard label remove
(05-15-2015 12:56 PM)TASP Wrote:  My first impulse would be to put an overlay over the marred label.

I had the same though - and a few sticker overlays that could fit the bill. Mind you, not for the standard keyboard but the SandMath, and 41Z; thus you'd have that looking at you permanently which can be perhaps overwhelming and probably not what you want.
Find all posts by this user
Quote this message in a reply
05-19-2015, 09:07 AM
Post: #4
RE: HP41C keyboard label remove
Hi,
just to report that I have done it, with the help of a hairdryer.
It looks acceptable, but it has some bends and marks that are very difficult to avoid.

Thanks a kind regard

Ignacio
Find all posts by this user
Quote this message in a reply
05-23-2015, 01:30 PM
Post: #5
RE: HP41C keyboard label remove
Ignacio, good luck with it!
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)